966 Rebuild
(5/30/01)

The brand new fuel cell has just arrived.

We pulled all of the foam out in order to put the cell in the car, here is the foam laying as it would in the cell.

Here Danny is putting the foam back into the cell which is already in the car.

All of the foam is in place, and the front plate and make up tank have been put back. All of the lines are connected and ready.

Now the filler necks and the low fuel sender are also being attached.

Martin and Danny pulled the front corners off the car and are going through them.

Martin is pulling the hub apart to look at the wheel bearing and to inspect the upright from the inside.

After re-packing the wheel bearings the hub is going back together. When it gets put back on the car the rotors and brake pads will be replaced.

<<< Previous Update | Next Update >>>